How to Make Loops Sound Like They Were Recorded to Tape

4 Min Read

Put a clean synth loop next to the same part played back from an old cassette and the difference is obvious within a bar. The tape version is warmer, softer at the top, a little unsteady in pitch and somehow easier to sit in a mix. None of that came from the notes or the synth. It came from the medium. That is good news, because it means the sound can be rebuilt in stages, and you get far more control doing it that way than by reaching for a single "lo-fi" plugin and turning it up.

Worn VHS tapes and a 4-track cassette recorder on a dark desk in warm side light.

The sound of the era was the sound of the machines it was stored on.

01

Start With the Wobble

Tape never plays back at a perfectly steady speed. The slow drift is called wow and the faster shimmer is called flutter, and together they give a held pad or chord that gentle, seasick movement people associate with old recordings. Recreate it with a chorus or vibrato set very slow and very shallow, then add a second, faster and even subtler modulation on top.

Keep the depth lower than feels right on solo. On a sustained part, a few cents of drift is plenty. If you can hear it as an effect, it is too much; if the part only feels more alive, you are there.

02

Narrow the Bandwidth

Consumer tape and VHS audio simply did not carry the full frequency range. Roll off the top end with a gentle low-pass somewhere between 8 and 12 kHz, and trim the very lowest sub with a high-pass. Many tape machines also had a "head bump", a soft lift in the low end, so a broad, small boost around 60 to 100 Hz completes the picture.

This is the stage that does the most work. A loop with its sparkle removed immediately sounds older and sits behind the vocal or lead instead of fighting it.

A close-up of cassette tape reels turning in soft magenta and teal light.

Every pass through the heads takes a little off the top.

03

Drive It Gently

Tape compresses and saturates as you push more level into it. The peaks round off, the quieter detail comes up and the whole part thickens. Use a saturation or tape plugin with the drive set low and the output matched, so you hear the change in tone rather than a change in volume. A soft-knee compressor after it, with a slow attack, glues the result together.

"The retro sound is what the medium does to a recording, so build it in stages."

04

Add the Noise, Then Print It

Finish with a quiet bed of hiss under the part, low enough that you notice it mostly when the music stops. Occasional tiny level dips, the dropouts of a worn tape, add realism on long pads. Then bounce the result to audio. Committing the sound stops you endlessly tweaking four plugins and lets you treat the loop like a recording again.

Of course, the most convincing way to get tape character is to record through real tape, and that is exactly how Beta Retrowave Melodics was made. Every loop was recorded direct to VHS and 4-track tape, so the wobble, warmth and grit are already in the audio. Two volumes, 105 loops of bass, arps, leads, pads and SFX, organised by type, key and tempo in 24-bit WAV.

Beta Retrowave Melodics sample pack cover art.
Featured in this article

Beta Retrowave Melodics

'80s synth loops recorded direct to VHS and 4-track tape. 105 loops of bass, arps, leads, pads and SFX across two volumes.

$24.99Shop Now

Whichever route you take, work in that order: wobble, bandwidth, drive, noise. Each stage is small on its own. Together they turn a clean loop into something that sounds like it has been sitting on a shelf since 1986.

An old CRT television glowing blue with tracking lines in a dark room.

Press play, adjust the tracking, and let it drift.

Browse the Frequencies archive.

Follow us on Instagram →

0 comments

Leave a comment

Please note, comments must be approved before they are published